When configured as a trunk port, a port is added as a member of all the existing VLANs and also any new VLAN created.
Show vlan device info - Displays the VLAN related global status variablesĬonfigures the priority for the tunneled STP BPDUs.
To configure the bridge mode of the switch:.If multiple bridge modes are required, run multiple instances of the bridge. Only one bridge mode can be set at a time.SEFOS(config)# bridge-mode provider-backbone-icomp Provider-backbone-bcomp - Provider backbone bridge B component mode.īased on the bridge mode value in issnvram.txt. Provider-backbone-icomp - Provider backbone bridge I component mode. Provider-edge - Provider edge bridge mode. Provider-core - Provider core bridge mode.
No mac-address-table static unicast aa:aa:aa:aa:aa:aa vlan 1-4094 [
#Show mac address vlan software
VLANs are configured through software rather than hardware, which makes them extremely flexible. That is, a network of computers that behave as if they are connected to the same wire even though they may actually be physically located on different segments of a LAN. VLANs can be viewed as a group of devices on different physical LAN segments which can communicate with each other as if they were all on the same physical LAN segment.
#Show mac address vlan manual
Sun Ethernet Fabric Operating System CLI Base Reference Manual